Pulsar’s gone. Whatever.
Stop sending me emails to tell me I’m whipped. You don’t even know what that means. I’ve done my thing and it’s time to move on. These have been easy decisions… I’m sad to be leaving, but…
Pulsar’s gone. Whatever.
Stop sending me emails to tell me I’m whipped. You don’t even know what that means. I’ve done my thing and it’s time to move on. These have been easy decisions… I’m sad to be leaving, but…
It dumped a bucket of snow last night. Must’ve been like 30cm worth. My travels today took me a short distance out of the city, where I stumbled upon unplowed roads. I never made it to my final destination, because…
So I’ve made real life harder than it should be, with my somewhat extravagant car life these past ten years. Makes for some difficult decisions.
And… Sunday morning, at the rally-x, after I just tagged three cones (one of which…

Rally-x today. I told Andrew that if I beat him I’d be happy. I always downplay my cars. Truth is, the Pulsar has 100hp more, and studded tires, which probably did a whole bunch on a couple major ice…
Gearing up for rally-x tomorrow. Installed some Sparco mudflaps, and gave the undercarriage a second coating of rubber. It’s amazing how much those two things quiet the car down on an ugly road. The front mudflaps are a pretty hard tune set up though. They’re only about 1cm off the ground which means they rub and scrape everywhere. I should have put them a little bit higher, but I want the most efficiency out of them. I’m not into rock chips. They stick about 1″ from the body, front and back. The rear ones don’t have to do so much more to protect the car though. There’s basically no rear over hang. I also didn’t want the rear ones low, because they can get caught in the tire and ripped off when backing up, a lot easier than the fronts can. So as you can see… the rear ones sit a lot high, which somehow helps create a raked look. [...]
RNN14 was out of commission for a couple days while I waited for a new outer tie-rod end. Took a couple tries to get the right part… finally went to Brasso and learned that 95 Sentra’s share the same tie-rod…
Something is loose on the front of the N14… which makes me sad. Feels like a wheel bearing. I need to learn a lot about this car.
It has begun to grow on me though. The attention I received on…